Process Comparison Dry Polishing vs Wet Polishing Which Surface Finish Method is Best Choosing between two finishing processes requires understanding how each method applies energy to the media, how the media contacts the part, and how the process variables scale with batch size and production rate. This comparison covers the key differences to help you decide which process matches your production...
Surface Finishing Magnetic Finishing Machine Guide for Deburring Small Metal Components This guide covers the key factors to consider when planning a surface finishing process for your parts. Material, geometry, batch size, and target surface quality all influence the choice of equipment, media, compound, and process parameters. This guide is based on common surface finishing scenarios observed ac...
Stamped Parts Finishing Guide How to Deburr Stamped Metal Parts Without Tangling, Distortion, or Part-on-Part Damage Stamped washers, clips, brackets, and thin sheet-metal parts can be efficient mass-finishing candidates, but their geometry creates risks that solid machined parts do not have. This guide explains how to evaluate the burr, select a machine and media, control part interaction, and bu...
Printable Process-Control Resource Mass Finishing Sample Trial Record for Small Precision Parts Use this non-promotional worksheet to define the incoming part, record one controlled finishing trial, compare results, and decide whether the process is ready for a repeat run. Important: This record does not replace a drawing, control plan, safety procedure, material compatibility review, or customer ...
IPv6 network supported 
+86-592-2381506 